One main space of problem for the model practice modeler is miniature connectors for HO, HOn3 and Sn3 scale steam locomotives.

There’s a producer, known as Miniatronics Corp., that produces cables with female and male connectors for using the aforementioned scale steam locomotives. The issue is that the backshell is to stiff and lengthy. I’ve tried utilizing them on giant steam engines however the mixture of the backshell and wire harness lifts or flips the tender off the observe. That is very true when the engine is in a curve or going via a swap/turnout trx connector B087JMT7NZ.

There are different connectors however they’re too giant for these three scales. The exception is Soundtraxx who produce single conductor units (male & feminine) for this specific utilization. The issue with any such connector is the modeler finally ends up with a number of single connectors dangling between the tender and engine. Typically you want 5 wires with connectors between the tender and engine.

The one corporations that carry the kind of connectors wanted for these scales are Bachmann, Athearn and Walthers Heritage sequence. The issue the modeler faces is that these corporations won’t promote the connector units to a buyer until it’s for a substitute for a broken set on certainly one of their locomotives.

I’ve tried Bachmann and Athearn personally with damaging outcomes. Walthers didn’t have any of their connectors in inventory. Walthers, who appear to need to promote something that pertains to model railroading, could promote the connector units they produce for his or her Heritage sequence. This difficulty I should pursue additional and can report on my success or failure within the close to future.

The requirement is to have totally different connector units that may be accommodated between the steam engine and it is tender. The wants are as follows:

Connectors For Use With HO Locomotives

Leave a Reply

Your email address will not be published. Required fields are marked *